Tips & Tricks

For a successful and precise fit we need optimum models.
Basically this means that

the preparation margin must be clearly ditched,
stumps must not be varnished. Please block out only in cases of undercuts or larger defects,
stumps or dies must not be coated with superglue or varnish,
the length of the stump or die is not more than 12.5mm,
the length of bridge is shorter than 48mm,
a wax up is always preferred,
a wax up does not have to be modelled with a final margin.
the colour or shade of the tooth is included in the information you send us.

Individual crowns

A single stump or die will do. We recommend sending in the complete saw-cut model to build an optimal framework.
A bite impression with a counter bite-impression helps us to model the framework more exactly.

Bridges

The saw-cut model with impression and counter-impression is best.
A bite impression with counter bite impression is needed to make the modulation supporting the ceramic.
All segments of the saw-cut model must be easy to reposition.
All abutments posts have to be measured and should have an angle of at least 4°!

Implant abutments

Please grind in a clear circumferential step or chamfer for rotation security
Please do not forget the analogue model and titanium setup!

Saw-cut model

All saw-cut elements must be easy to remove and reposition.

Processing

Tips for processing

Use only a water-cooled turbine for proper processing.
Very small areas can be carefully dried and worked with a fine diamond.
Connecting parts of bridges must never be reduced.
The calculation of the profile or lateral cut is designed with stability in mind.
After working, finish off the area to be veneered with a rubber wheel (Shofu)
Do not blast!

Your personal consultant is always pleased to be of assistance
should you have any questions.

Contact them today.